Installation

After ensuring the you meet both the hardware and software requirements and that your display is connected.

Steps

To install run the following command in your pi's terminal:

1. curl -S https://raw.githubusercontent.com/jcari-dev/display-hub-e-ink-display-dashboard/refs/heads/main/setup.sh | bash
2. Done. 🎉

Please note When the installation is successful you should see the following message:

Note: There's currently not a hostname setup for the forwarding address, so as highlighted on the image, the address to access the web GUI will be the local IP address of the device.

Upon accessing the provided URL, you will be redirected to the homepage:

For troubleshooting please refer to the troubleshooting installation page here.